Apex Pro
The enhanced Apex Pro is a fully programmable, enhanced version of the Apex personal sampling pump. It has on board data-logging and is capable of storing up to 100 sets of data; which include, start and stop times, flow rates, average sample temperature, volume sampled and any error events that may have occurred. Whenever the pump is started and stopped data logging is enabled. This data is increasingly being demanded for auditing and legislative purposes.
Communication to the Apex Pro is via the infra red interface connector. This can be connected to the PC via the RS232 port. Once the program is running on the PC, it will detect any pump within the beam and data automatically downloaded.
The Apex Pro can also be configured via the software with 3 additional program modes of operation that can be utilized and uploaded into the pump:
Duration:
The duration program is available for both the Apex standard and Programmable version, and a sampling duration can be entered via the pump keypad. This allows the supervisor or user to issue the pump in the knowledge that it will cease sampling at the end of the duration set.
TWA:
This is where the operator needs to sample a set volume but possibly needs this to be a representative sample over a whole sampling period. (Some NIOSH methods work on this principle.) The required sample duration is entered into the software and then the required on sample time is calculated by the user and entered in. The pump will switch on and off throughout the sampling duration.
Time Schedule Program
These are two real-time scheduling programs which allow the operator to pre-program the pump with start & stop times. Up to 9 on/off routines can be made for each program.
Spare/Accessories:
Apex Drop In Charger
Pump Manager Software
Emergency Dry Cell Battery Pack (Apex)
Spare Battery (Apex)
Standard Starter Kit
Upgraded Starter Kit
Also
|
